Requesting Information; Local Operation (Bus Device) - ABB TZIDC-110 Operating Instructions Manual

3.4.3 Requesting information

Additional information can be called up for display by briefly pressing the buttons shown
in the table when the bus mode is active (i.e. the following display is seen):
conf
Buttons pressed
ENTER

3.4.4 Local operation (bus device)

Procedure for mode selection from operating level:
• Press and hold
• Additionally briefly press
The selected operating mode is indicated.
• Release
The position is indicated as a percentage or rotation angle.
Overview
1.1
Positioning with fixed setpoint. Setpoint
can be adjusted by pressing
1.2
Manual adjustment* within the opera-
ting range. Press
1.3
Manual adjustment* within the sensor
range. Press
*) Positioning not active
**) For quick motion: Press
28
°
C
%
mA
Cyclic communication:
The setpoint value in % and the setpoint state are indicated.
Acyclic communication:
The communication state is indicated.
The operating mode on the bus and the bus address are shown.
The software revision level is indicated.
.
MODE
as often as required.
MODE
Mode
or
or to adjust.**
or to adjust.**
and
Electro-pneumatic positioner TZIDC-110
Action
Mode display
.
conf
conf
conf
together.
Position display
°
C
%
mA
conf
° C
%
mA
conf
° C
%
mA
conf
41/18-77 EN
°
C
%
mA
°
C
%
mA
° C
%
mA