ABB TZIDC-110 Operating Instructions Manual page 26

5. Run the standard Autoadjustment function.
- Make sure that the remote level is activated.
For linear actuators
- Press and hold
release
- Press and hold
then release
Standard Autoadjustment is started automatically, and the progress is displayed.
For rotary actuators
- Press and hold
-
conf
- Wait until the display has changed to
conf
- Release
- Press and hold
- Release
Standard Autoadjustment is started automatically, and the progress is displayed.
When standard Autoadjustment has completed successfully, the determined parameters
are saved automatically, and the remote level is activated again. If, however, an error
should occur during standard Autoadjustment, error code 255 is briefly indicated. The
device then automatically changes over to parameter P1.1 Autoadjust (custom autoad-
justment) at the configuration level.
- Press and hold
- Additionally, briefly press
-
conf
- Release
- Press and hold
The positioner automatically returns to the operating level. Press and hold
additionally briefly press
the sensor range". Then check the positioner-actuator assembly for proper mounting.
Re-adjust if required (see chapter 3.1.3 or chapter 3.1.4 for details) and then start stan-
dard Autoadjustment again.
1. The zero position is automatically determined and saved by the standard autoadjustment function:
turning counter-clockwise (CTCLOCKW) for linear and clockwise (CLOCKW) for rotary actuators.
26
1
:
. Wait until the countdown has run down from 5 to 0, then
MODE
.
MODE
again until the countdown has run down from 3 to 0,
MODE
.
MODE
1
.
ENTER
° C
%
mA is displayed.
°
C
%
mA
.
ENTER
again until the countdown has run down from 3 to 0.
ENTER
.
ENTER
.
MODE
°
C
%
is displayed.
mA
. CANCEL is displayed. If not, briefly press
MODE
until the countdown has run down from 3 to 0.
ENTER
twice to reach operating mode 1.3 "Manual adjustment within
Electro-pneumatic positioner TZIDC-110
or several times until.
or .
and
MODE
41/18-77 EN