Commissioning; Procedure - ABB TZIDC-110 Operating Instructions Manual

3.4 Commissioning

3.4.1 Procedure

1. Turn on the air supply to the positioner.
2. Connect the bus with arbitrary polarity (or auxiliary power 9 V DC ... 32 V DC)
to the bus terminals.
conf
3. Check for proper mounting:
- Press and hold
has run down from 3 to 0, then release
level (mode 1.x) is reached and indicated.
- Press and hold
- Additionally briefly press
sensor range) is displayed.
- Release
- Press
and note the values. The angle of rotation is indicated in degrees.
Recommended range:
between -28° and +28° for linear actuators
between -57° and +57° for rotary actuators
Minimum angle: 25°
IMPORTANT
4. Return to the remote level.
- Press and hold
- Wait until the countdown has run down from 3 to 0, then release
ENTER
conf
41/18-77 EN
°
C
%
mA is displayed.
M
and
ODE
.
MODE
.
MODE
or to move the actuator to its mechanical limit stops in both directions,
The positioner should be mounted/adjusted in such a way that the porti-
ons of the sensor's operating range above and below the center point are
nearly identical. Make sure to use the rotation angle of the position sen-
sor in the positioner to its utmost extent. Refer to chapter 3.1 "Mechani-
cal mounting" for details about how to readjust/correct if required.
and
MODE
.
°
C
%
is displayed.
mA
Electro-pneumatic positioner TZIDC-110
E
simultaneously. Wait until the countdown
NTER
M
ODE
or until mode 1.3 (manual adjustment within the
.
ENTER
E .
and The operating
NTER
MODE
and
25