Setting The Bus Address - ABB TZIDC-110 Operating Instructions Manual

3.4.2 Setting the bus address

• Switch the positioner over from the remote level to the operating level: Press and
hold
MODE
to 0. Release
• Switch the positioner over to the configuration level: Press and hold
neously and then additionally briefly press and release
pressed until the countdown from 3 to 0 is finished (approx. 3 seconds) and only
then release them. Otherwise, the change-over to the configuration level will fail.
conf
• Press and hold
conf
M
• Release
conf
• Press the
• Press and hold
. The new bus address is saved.
ENTER
• Press and hold
conf
• Switch the positioner back to the operating level: Press and hold
countdown has run down from 3 to 0. Release
• Return from the operating level to the remote level: Press and hold
ENTER
and
MODE
41/18-77 EN
and simultaneously until the countdown has run down from 3
ENTER
and
MODE ENTER
°
C
%
mA
is displayed
. Additionally press
MODE
°
C
%
mA
is displayed
.
ODE
° C
%
mA
is displayed (factory setting)
or button to increment or decrement the bus address.
until the countdown has run down from 3 to 0. Then release
ENTER
. Additionally press
MODE
° C
%
is displayed. Set the parameter to NV_SAVE by using
mA
simultaneously until the countdown has run down from 3.0. Release
.
ENTER
Electro-pneumatic positioner TZIDC-110
.
or until
or until
ENTER
and
once. Keep
ENTER
ENTER
.
MODE
simulta-
and
or .
until the
and
27