Assembling The Cutting Equipment; Fitting The Trimmer Guard And Trimmer Head - Husqvarna TA1100 Operator's Manual

Hide thumbs Also See for TA1100:
Table of Contents

Advertisement

Assembling the cutting
equipment
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
Fitting the trimmer guard and
trimmer head
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
A
Fit the drive disc (B) on the output shaft.
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) counter
clockwise.
H
H
To dismantle, follow the instructions in the reverse
order.
8 – English
ASSEMBLY
B
C
A

Advertisement

Table of Contents
loading

Table of Contents