Assembly; Fitting The Loop Handle; Assembling The Cutting Equipment; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 426LST Operator's Manual

Fitting the loop handle

• Position the loophandle on the shaft. Note that the
handle must be mounted below the arrow on the shaft.
• Slide the spacer into the slot in the loop handle. Fit the
nut and screw. Tighten.
Assembling the cutting
equipment
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
!
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
10 – English

ASSEMBLY

Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head.
• Tighten the two screws.
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head (D) in the opposite
direction to the direction of rotation.
A
1155667-49 Rev. 2 2015-02-05