Activating A Port Group Monitor Policy; Displaying Port Group Monitor Status And Policies - Cisco MDS 9000 Series Configuration Manual

Configuring Port Group Monitor
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Turning Off the Monitoring of a Specific Counter
When the no monitor counter command is used in the config-port-group-monitor mode, it turns off
the monitoring of the specified counter in the given policy as seen in the following example:
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Performance
TX Performance
------------------------------------------------------------------------------------------
switch(config)# port-group-monitor name PGMON_policy
switch(config-port-group-monitor)# no monitor counter rx-performance
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Performance
TX Performance
------------------------------------------------------------------------------------------

Activating a Port Group Monitor Policy

To activate a port group monitor policy, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# port-group-monitor activate
policyname
switch(config)# port-group-monitor activate
switch(config)# no port-group-monitor
activate policyname

Displaying Port Group Monitor Status and Policies

The following commands display information about port group monitor:
switch# show port-group-monitor status
Port Group Monitor : Enabled
Active Policies : pgm2
Last 10 logs :
switch#
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
2-42
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ---------------------- ------
Delta 26
Delta 60
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ---------------------- ------
Delta 26
Delta 60
450 250
100 80
450 250
100 80
Purpose
Enters configuration mode.
Activates the specified port group monitor
policy.
Activates the default port group monitor policy.
Deactivates the specified port group monitor
policy.
OL-19445-02, Cisco MDS NX-OS Release 4.2(x)
Chapter 2 Configuring Interfaces
In Use
Yes
Yes
In Use
No
Yes