Enabling Or Disabling The Catena Solution; Configuring A Port Group - Cisco Nexus 9000 Series Configuration Manual

Enabling or Disabling the Catena Solution

3 Create a VLAN group.
4 Create a device group.
5 Create an IP ACL.
6 Create a Port ACL.
7 Create a catena instance.
Enabling or Disabling the Catena Solution
By default, catena is disabled on the Cisco NX-OS device. You must explicitly enable catena to configure
and verify authentication commands.
Before You Begin
Ensure that you have installed the network services license.
SUMMARY STEPS
1. configure terminal
2. [no] feature catena enabling or disabling
3. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 [no] feature catena enabling or disabling
Example:
switch(config)# feature catena
Step 3 copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config

Configuring a Port Group

A port group consists of a set of interfaces. You must configure port groups for both routed and transparent
modes.
Cisco Nexus 9000 Series NX-OS Catena Configuration Guide, Release 7.x
8
Purpose
Enters global configuration mode.
Enables catena. Use the no form of this command to disable
catena.
When you disable catena, all related configurations
Note
are automatically discarded.
(Optional)
Copies the running configuration to the start up
configuration.
Configuring the Catena Solution