Weller WXD 2 Operating Instructions Manual page 36

WXD 2
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
temperature is within the predetermined process window.
− A flashing LED indicates that the system is heated or that the
temperature is outside the process window.
7.2 Setting the station parameters
Please observe the overview diagrams (Fig. 1 and Fig. 2).
Selecting the menu navigation language
1. Call up the parameter menu.
2. Select and confirm the menu option Language.
3. Set the required language with the turn-and-click wheel (7).
4. Confirm the value with the Enter key (8).
Changing the temperature units display
1. Call up the parameter menu.
2. Select and confirm the menu option Temperature units °C/°F.
3. Set the required temperature units with the turn-and-click
wheel (7).
4. Confirm the setting with the Enter key (8).
Switching the lock function on/off
After switching the lock function on, only the fixed temperature keys
(= control keys 1, 2, 3 and 4) can be operated on the soldering
station. All other settings are disabled until the repair station is
unlocked again.
Note If you want only one temperature value to be selectable, the control
keys 1, 2 and/or 3, 4 (fixed temperature keys) must be set to the
same temperature value.
Lock the soldering station:
1. Call up the parameter menu.
2. Select and confirm the menu option Password.
3. Set the required three-character locking code
(between 001-999) with the turn-and-click wheel (7) (see Fig. 26).
4. Confirm the value with the Enter key (8).
The lock is active (the display shows a lock symbol (32), see also
Fig. 27).
Unlocking the soldering station
1. Call up the parameter menu.
If the lock function is active, the password menu item opens
automatically. Three stars (***) are shown on the display.
2. Set the three-character locking code using the turn-and-click
wheel (7).
3. Confirm the code with the Enter key (8).
15-21