Table of Contents
Advertisement
BEFORE YOU BEGIN
Receiving
The shipment should be thoroughly inspected as soon as it
is received. The signed bill of lading is acknowledgement,
by the carrier, of receipt in good condition of the ship-
ment. If any of the goods called for on the bill of lading are
shorted or damaged, do not accept them until the carrier
makes a notation of the shorted or damaged goods on the
freight bill. Do this for your own protection.
NOTIFY THE CARRIER AT ONCE if any hidden loss or
damage is discovered after receipt. IT IS DIFFICULT TO
COLLECT FOR LOSS OR DAMAGE AFTER YOU HAVE
GIVEN THE CARRIER A CLEAR RECEIPT. File your
claim with the carrier promptly. Support your claim with
copies of the bill of lading, freight bill, invoice, and photo-
graphs if possible.
Unpacking and Setup
Handling of the machine must be performed only with an
appropriate lifting device such as a forklift or pallet jack.
Only personnel who are experienced and
qualified on material handling procedures should handle
any transportation or moving of machine.
1. Remove the carton from the pallet.
2. Remove the shipping bolts making sure to keep hands
clear of all pinch points.
3. Remove straps and plastic wrap holding the hood
other components in shipping position.
The Accessory Box is packaged inside the Balancer.
When lifting the Balancer off the pallet, remove the
Accessory Box from the inside of the Balancer.
•
Do not use the face-plate, hood or threaded shaft to lift
the balancer.
•
Use help to remove the balancer from the pallet. The
unit is heavy and the weight is not evenly distributed.
•
Dropping the unit from the pallet may cause personal
injury or equipment damage.
NOTE:
Electrical Requirements
STANDARD WIRING IS 220 VOLT 50/60Hz.
Consult a licensed electrician for electrical hook-up
according to local electrical codes. Operation with no
ground can damage electronics and will create a shock
hazard for the operator or bystanders. Damage caused
by improper electrical installation may void warranty. Most
electrical codes require "hard-wiring" when the machine is
bolted to the floor. Consult a licensed electrician regarding
specific codes.
Floor and Space Requirements
The balancer MUST be located on a flat floor of solid
construction, preferably concrete. The balancer MUST sit
solidly on the floor. If the balancer is not level, or is placed
on an unstable floor, the balancer will not function properly
and will produce inaccurate balance readings.
The balancer may be bolted down. It will NOT function
properly if operated on the pallet.
•
Select a location for the balancer that provides a level,
solid floor, and adequate clearance around and above
the balancer.
•
Make sure the location selected has enough room
above and behind the unit so the hood can be raised
completely.
•
The location must also provide working room for
mounting and removing wheels.
5
Hide quick links:
Advertisement
Table of Contents
