Table of Contents
Advertisement
Wheel Width Data
NOTE: This section only applies to the DST-64T models.
This is the width of the wheel at the inner edges. To enter
Wheel Width data refer to the instructions below.
1. Position the outer gauge arm against the outside edge
of the wheel, hold it there until you hear a beep.
2. The wheel width reading will be displayed in the lower
width window.
NOTE: If this number is not correct you will need to
perform the outer gauge arm calibration procedure.
NOTE: Wheel Width Data must be entered manually on
DST-64T models.
Inputting Wheel Data Manually
If there ever comes a time when the automatic data input is
not working correctly you can input the information
manually following the steps below.
WHEEL DATA KEY BOARD
dis - Wheel Offset
This is the distance between the side of the balancer and
the inner edge of the wheel. To enter Wheel Offset data
refer to the instructions below.
1. Turn the machine on.
2. The offset data will be displayed in the INNER window.
3. Pull the index arm out from the side of the machine until
the tip touches the inner edge of the wheel.
4. Read the offset measurement as displayed on the scale
directly on top of index arm. Press the corresponding
+ -
buttons below
L - Wheel Width
This is the width of the wheel at the inner edges. This
distance is measured with the calipers. To enter Wheel
Width data refer to the instructions below.
1. Position the calipers over the wheel and touch the tips
against the wheel edges.
2. Read the measurement for Wheel Width shown on the
calipers. (Use the proper scale for Width)
3. The width data will be displayed in the INNER window.
4. Press the corresponding
enter the correct data.
IMPORTANT NOTE: The standard setting for this
operation is shown in INCHES. If metric is desired, new
calipers with metric readings will have to replace the
calipers that accompanied the unit. (See page 12 for
changing "L" reading to MM or INCH setting.)
17
to enter the correct data.
+ -
buttons below
to
Hide quick links:
Advertisement
Table of Contents
