Table of Contents
Advertisement
ALU EXACT TWO PLANE MODE
This is a mode used if stick-on weights are to be mounted
to the Inner and Center planes of the wheel. Both the
distance and width parameters are accurately defined for
a more exacting weight placement, therefore improving the
likelihood of a single spin balance.
1. Press the ALU button until the light of ALU is
illuminated.
2. You can also access to ALU by pressing the STOP and
ALU buttons at the same time and then press the ALU
button once again to obtain the ALU function.
3. Pull the index arm out from the side of the machine and
touch the position of the left weight position or inner
plane. Wait for a beep. From the left weight position
pull the index arm out to the right weight position or
center plane. Wait for the beep. ALU will display on
the screen, return the index arm to the rest position.
4. The inner plane data will read in the INNER window
and the center plane data will read in the center
WIDTH window.
5. The diameter reading shown in the OUTER window is
the diameter for the inner plane.
6. Lower the hood or press the START button to spin the
wheel.
7. After the wheel stops, weight readings for the wheels
inner plane will read in the INNER window and readings
for the center plane will read in the OUTER window.
8. Turn the wheel by hand until you see the weight
position indicator lights on the side marked OUTER
are FULLY ILLUMINATED. This indicates the position
specified by the balancer for the right weight position or
center plane. Step on the foot brake.
9. Attach the specified weight for the CENTER PLANE
position to the weight applicator at the end of the index
arm.
Weight Applicator
10. Pull the index arm out to the center plane position,
the center WIDTH window will count down for you and
display --0 when you have approached the correct
position.
11. Push up on the weight applicator at that position
making sure the weights are fully adhered to the
wheel, return the index arm to the rest position.
Release the brake.
12. Turn the wheel by hand until the weight position
indicator lights on the side marked INNER are FULLY
ILLUMINATED. This indicates the position specified by
the balancer for the left weight position or inner plane.
Step on the foot brake.
13. Attach the specified weight for the INNER PLANE
position to the weight applicator at the end of the
index arm.
14. Pull the index arm out to the inner plane position, the
center WIDTH window will count down for you and
display --0 when you have approached the correct
position.
15. Push up on the weight applicator at that position
making sure the weights are fully adhered to the
wheel, return the index arm to the rest position.
Release the brake.
If the index arm is not returned to the full resting position
the balancer will not spin. Make sure when not in use the
index arm is always resting in its holder.
19
Weight
NOTE:
Hide quick links:
Advertisement
Table of Contents
