Table of Contents
Advertisement
"dia" - Wheel Diameter
This is the diameter of the wheel at the rim flanges. This
measurement can be read on the tire sidewall or
measured. To enter Wheel Diameter data, refer to the
instructions below.
1. Read the diameter of the wheel as shown on the tire
sidewall or use the Calipers to measure the wheel
diameter. (Use the proper scale for Wheel Diameter)
2. The diameter data will be displayed in the lower
diameter window.
3. Press the corresponding
enter the
correct data. (See page 10 for changing
"d" reading to MM or INCH setting.)
Spin Mode / DYNAMIC
1. Once the correct wheel data and FUNCTION have
been programmed, lower the hood to begin the spin
mode.
Before initiating the spin sequence, make sure that the
Quick-Nut is secure and engaged on the arbor threads
by at least four (4) full turns. Never hammer or hit the
Quick-Nut to tighten.
2. After the hood is lowered, or the START button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, weight readings for each side of
the wheel (INNER and OUTER) will appear in the
center display screen.
4. Turn the wheel by hand until you notice the weight
position indicator lights on the side marked INNER are
+ -
buttons below
FULLY ILLUMINATED. This indicates the position
specified by the balancer for the inner weight position.
5. Attach the specified weight for the appropriate PLANE
position at top-dead-center.
To hold the wheel in position when installing weights,
press down on the TIRE STOP PEDAL located on the
right side of the machine.
All weight positions are located at TOP-DEAD-CENTER.
The more accurate you are in selecting the exact weight
and position, the more accurate the wheel will be
balanced.
6. After the INNER weight is properly installed, turn the
wheel by hand until the weight position indicator lights
on the side marked OUTER are fully illuminated. This
indicates the position specified by the balancer for the
OUTER weight position.
to
7. Attach the specified weight for the appropriate PLANE
position at top-dead-center.
Spin Mode / STATIC & STATIC 2
This function is used if weights can only be mounted on a
single plane of the wheel.
1. Once the correct wheel data has been programmed,
lower the hood to begin the spin mode.
2. After the hood is lowered, or the START button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, a weight reading will appear in
the center display screen marked width.
4. Turn the wheel by hand until the weight position
indicator lights on both the INNER & OUTER are fully
illuminated.
5. This indicates the position specified by the balancer for
the desired weight location on the chosen PLANE.
6. Attach the specified weight on the PLANE of the
wheel at top-dead-center.
18
NOTE:
NOTE:
Hide quick links:
Advertisement
Table of Contents
