Table of Contents
Advertisement
Chapter 3 Features and Functions
Triggering
Software (Bus) Triggering The bus trigger mode is available only
from the remote interface. This mode is similar to the single trigger
mode from the front panel, but you trigger the function generator by
sending a bus trigger command. The function generator outputs one burst
or initiates one sweep each time the trigger command is received.
• To select the bus trigger source, send the following command.
"TRIGGER:SOURCE BUS"
• To trigger the function generator from the remote interface (
-232), send the *TRG (trigger) command.
RS
• You can also trigger the function generator from the
by sending the
-488 Group Execute Trigger (
IEEE
The following statement shows how to send a
TRIGGER 710
• The following statement shows how to send a trigger from the
interface using the
HP-IB
IOTRIGGER (710)
GET
Group Execute Trigger
Command Library for C or QuickBASIC.
or
HP-IB
interface
HP-IB
) message.
GET
using HP BASIC.
HP-IB
101
3
Advertisement
Table of Contents
