Table of Contents
Advertisement
Chapter 3 Features and Functions
Triggering
Triggering
Applies only to bursts and frequency sweep. You can issue triggers for
bursts and sweeps using internal triggering, single triggering, or
external triggering.
• Internal or "automatic" triggering is enabled when you turn on the
function generator. In this mode, the function generator outputs
continuously when the burst mode or sweep mode is selected.
• Single triggering outputs one burst or initiates one sweep each time
you press
from the front-panel. Continue pressing this key to
Single
re-trigger the function generator.
• Pressing
to enable the single trigger mode also enables the
Single
external trigger mode. External triggering is like the front-panel
single trigger mode except that you apply a trigger signal to the
rear-panel Ext Trig terminal. The function generator is triggered on
the rising edge of a
TTL
• The
key is disabled when in remote (the
Single
turns on when in remote) and when a function other than burst or
sweep is selected.
98
pulse.
annunciator
Rmt
Advertisement
Table of Contents
