Table of Contents
Advertisement
Chapter 2 Front-Panel Menu Operation
To output a frequency sweep
∨
4 Move down a level and set the start frequency to 50 Hz.
Notice that the
parameter is for the sweep mode. For more information on editing
numbers in the menu, refer to "Menu Example 3" earlier in this chapter.
Enter
5 Save the change and turn off the menu.
The start frequency is now set to 50 Hz.
Shift
6 Use recall menu to return to the
<
The "recall menu" key returns you to the
Recall Menu
the last command used before you exited the menu.
>
7 Move across to the
∨
8 Move down a level and set the stop frequency to 5 kHz.
Enter
9 Save the change and turn off the menu.
At this point, the function generator outputs a continuous sweep from
50 Hz to 5 kHz.
You can generate one frequency sweep by pressing the "Single" key or
applying a trigger pulse to the rear-panel Ext Trig terminal. For more
information, see "To trigger a burst or sweep" on the next page.
50
annunciator flashes, indicating that the displayed
Swp
∧50.00
Hz
1: START F
STOP F
2: STOP F
∧5.000
KHz
command.
START F
command, which was
START F
command.
Advertisement
Table of Contents
