Table of Contents
Advertisement
Chapter 3 Features and Functions
Output Configuration
• You can set the units for output amplitude to Vpp, Vrms, or dBm.
See "Output Units" on page 64 for more information.
• For dc volts, the output level is actually controlled by setting the
offset voltage. You can set the dc voltage to any value between
±
into 50 ohms or
10 Vdc into an open circuit. See "DC Offset Voltage"
on page 62 for more information.
To select dc volts from the front panel, press
for more than 2 seconds
• Front-Panel Operation: To set the output amplitude, press
Then use the knob, arrow keys, or "Enter Number" mode to set the
amplitude.
• Remote Interface Operation:
VOLTage {<
amplitude
You can also use the APPLy command to select the function,
frequency, amplitude, and offset with a single command.
Offset
.
>|MINimum|MAXimum}
±
5 Vdc
and hold it down
3
.
Ampl
61
Advertisement
Table of Contents
