Wall Thermostat; Dc Spark Igniter Battery Install; Final Check - Regency ULTIMATE U38 Owners & Installation Manual

Gas
Hide thumbs Also See for ULTIMATE U38:
Table of Contents

Advertisement

installation
|
18
OPTIONAL

WALL THERMOSTAT

A wall thermostat may be installed if desired.
Connect the wires as per the wiring diagrams.
Note that the wires are connected to the "TH"
on the gas valve. Use table below to determine
the maximum wire length:
Note: Preferable if the thermostat is installed
on an interior wall.
Regency
offers an optional programmable
®
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
18 |
Regency
U38-10 ULTIMATE Freestanding Gas Stove
®
DC SPARK IGNITER BATTERY
INSTALL
Install supplied battery into the DC spark box.
1. Open pedestal front door.
2. Remove 2 screws that secure the front door
to the unit. One screw is on the left hand side
and the other on the right hand side. (Left side
shown).
3. Remove four screws and the chain attached
to the front door and the unit.
Max. Length
50 Ft.
32 Ft.
20 Ft.
12 Ft.
9 Ft.
4. The DC spark box will be exposed after re-
moving the valve cover.
Remove chain
here
DC Spark Box
5. Open the battery compartment door on the
DC spark box
6. Install battery into DC spark box.
7. Reverse steps 1 to 5.

FINAL CHECK

Before leaving this unit with the customer, the
installer must ensure that the appliance is firing
correctly. This includes:
1) Clocking the appliance to ensure the correct
firing rate (rate noted on label) at 15 minutes.
2) If required, adjusting the primary air to ensure
that the flame does not carbon. First allow the
unit to burn for 15 min. to stabilize.
3) Check for proper draft.
CAUTION
Any alteration to the product that
causes sooting or carboning that
results in damage to the exterior
facia is not the responsibility of the
manufacturer.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ultimate u38-lp10Ultimate u38-ng10

Table of Contents