Operating Instructions; Factory Default Settings; The Buttons - Ambirad SmartCom 3 Owner's Manual

3 Operating instructions.

3.1 Factory default settings

For speedy installation and ease of first
operation, the SmartCom³ is supplied from the
factory with pre-programmed default settings.
These are:
On / Day temperature
Off / Night temperature
ON time

3.2 The Buttons

The ten buttons have the following functions:
Press the + button to increase a value.
Press the - button to decrease a value.
Press the OK button to accept the value
and advance to the next display.
Press to cancel overtime, vent, exam*,
OFF and holiday modes or to cancel a
setting but save any previous changes.
Initialise and step through programming
modes.
Pressing the FAN ONLY button will
force the controller to operate Vent 1
r e l a y r eg ar d l ess
temperature while Heat relays are disabled.
Pressing the UNDO button, at any time will
cancel this operation.
Pressing the OVERTIME button in an
OFF period will initiate or extend the
day-time operation of the controller.
64°F
41°F
08:00 Mon thru Fri
o f th e ro om
7
OFF time 16:30 Mon to Fri
(no further ON/OFF times set or weekends)
Program mode Auto
Control type Warm Air*
Sensor type Internal*
Night setback On*
Frost protection On*
Networking Off*
Pin protection Off*
* can be altered within Engineers settings if required.
Pressing the UNDO button, at any time will
cancel this operation.
The controller can operate in holiday
mode, with frost protection for a number
of days. When the holiday period
expires the controller
operation. Pressing the UNDO button, at any
time will cancel this operation.
Pressing the CHECK TEMP button will
display the sensor (room) temperature
on the first press and the set (program)
temperature on the second press. The third
press will return the display to normal.
Pressing the LOCKOUT button will clear
a flame failure lockout.
the lockout, press and release the
LOCKOUT button. After 10 seconds the
controller will return to normal operation. The
lockout warning and LED will continue to display
if the flame failure signal is cleared at source.
Note:
If no keypad action takes place for 60
seconds, the current selection is cancelled
and the display returns to day and time and
previously set operating mode.
* Exam Heating mode (EH) will appear only if
selected in the engineer functions.
returns to normal
In order to reset