Engineer Settings; Introduction; Settings; The Engineer Variables - Ambirad SmartCom 3 Owner's Manual

4 Engineers Settings.

4.1 Introduction

The engineer functions allow you to program
various advanced parameters.
• All control functions may be optionally
password protected by a PIN code.
• Pressing
the UNDO
programming will cause the setting being
programmed to be changed back to its
original value.
• Pressing
the UNDO
consecutively, at any time while in the
In order to access the engineer functions:
Press and hold in the

4.2 Settings

CONTROL TYPE
RAD
press
DF & I DF
OFF SET/OK
follow 'WARM AIR' SETTINGS'
To aid the on-site engineer, the settings
have been arranged by heater type. The
default setting is radiant. For Warm Air,
simply alter the control type by using this
procedure.
Once the control type has been set, follow
the variables as described in the next
procedure.
Press the SETTINGS button to advance
to the next display.
Press the OK button to alter a setting or
accept the a new value.
Use the + button to toggle between /
increase the value.
• If no keypad action takes place for 60
button during
•
button twice,
button and at the same time, press the
+/-/OK
I ANT
or
CONTROL TYPE
RAD I ANT
20
engineer function, will cause the controller to
exit the engineer function and return to
normal operation. Only items which have
been OK'd will be changed.
seconds while in the engineer function, the
controller will exit the engineer function and
return to normal operation. Only items which
have been OK'd will be changed.
The engineer settings cannot be programmed
over the communications link, only on the
specific controller.
+/-/OK
press
CONTROL TYPE
A I R
ARM
press
CONTROL TYPE
ARM A I R
press
I NTERNAL SENSOR
ON
Use the - button to toggle between /
decrease the value.
Press the UNDO button to cancel
settings but save any previous changes.
button.
+/-/OK
SET/OK
SET/OK
.......etc