General Wiring Specifications - Ambirad SmartCom 3 Owner's Manual

Note: when used in dusty/contaminated
environments it may be necessary to locate
the SmartCom panel within an enclosure (or
locate panel remotely) and use an external
temperature sensor.

2.2 General Wiring Specifications

All wiring connections must be made by a
suitably qualified person.
When making connections to screw terminals
please ensure that no more than 1/4" of
insulation is stripped back and that no stray wire
strands escape.
Warning
Important: All electrical work should be done by a qualified electrician in strict accordance with
the National Electrical Code ANSI/NFPA 70. or Canadian codes CSA C22.1
Please refer to the following wiring connection
drawings and observe the note at the bottom of
each page referring to cable type and length.
Complete installation wiring instruction booklets
are supplied to suit
applications which can also be downloaded
from our website www.ambirad.com/us
It is important to read both the product
instructions and these control instructions to
ensure satisfactory operation.
Failure to follow these guidelines may result in
electrical interference
operation.
5
individual heating
or unsatisfactory