AEG BP861510K User Manual page 32

32 www.aeg.com
When the pyrolytic cleaning
starts, the appliance door is
locked.
To stop the pyrolytic
cleaning before it is
completed, deactivate the
appliance.
WARNING!
After the function is
completed, the appliance is
very hot. Let it cool down.
There is a risk of burns.
After the function is
completed, the door stays
locked for the cool down
phase. Some of the
appliance functions are not
available during the cool
down phase.
12.5 Cleaning the oven door
The oven door has four glass panels. You
can remove the internal glass panels to
clean them.
CAUTION!
Do not use the appliance
without the glass panels.
The direction in which you
open the door depends on
your oven model. You open
the door from the right side
in some models and from
the left side in others.
1. Press the buttons at the sides of the
door trim (A) on the upper cover and
pull it upwards to remove it.
2. Hold the inner glass B tightly with
both hands and slide it upwards to
remove it from its initial position. Do
the same with the other glass panels.
Make sure that you tightly hold the
glasses to prevent them from falling.
3. Clean the door with a wet sponge
and rub it dry with a soft cloth. Do
not use steel wool, acids or abrasive
cleaning agents because they can
damage the surface.
When the oven door is clean, install the
glass panels in the opposite sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The glass panel (C) has a small
dot on the top, the middle panel (B) has
a decorative frame. In some models, the
glass panel (A) has screen printings. In
others, it is transparent. The screen-
printing zone must face the inner side of
the door. Make sure that after the
A
B