Magnescale SJ300 SJ300 Manual page 17

3. Mounting the head
Refer to "5. Dimensions" for the mounting location. The slider can be mounted on
either side, and so mount it based on the direction that the cable is pulled out during
operation.
Mounting parallelism: 0.1 mm/0.004"
Tightening torque:
4. Mounting the scale brackets B and C
Attach the hexagonal bolts and hexagonal nuts to the scale brackets B and C on either
the right or left side, and assemble as shown in the figure. When attaching, temporarily
tighten hexagonal bolts 1, 2, and 3 so that the brackets will not fall off.
5. Mounting the scale brackets B and C on the opposite side
In the same way as step 4, assemble scale brackets B and C on the other side.
SJ300 Series
2.7 N m
•
Hexagonal bolt 1
Scale bracket B
Hexagonal bolt 2
Scale bracket C
Hexagonal bolt 3
9
(E)