Mounting Procedure - Magnescale SJ300 SJ300 Manual

3-2. Mounting Procedure

This section describes the standard mounting procedure for mounting with reference to the
head. This is an effective mounting method when the scale mounting surface has a casting
surface finish.
1. Mounting scale bracket A
Be sure to maintain flatness of the mounting surface within the range below.
Refer to "5. Dimensions" for the mounting location.
2. Securing the cable
Check that the scale power supply is turned off, and then connect the cable to the
slider. When connecting, be careful that the connector pin does not get bent.
(Connector set screw M2.6: Tightening torque: 0.3 N
After connecting the cable, be careful that no force is applied to it.
8
(E)
Diameter:
16 mm/0.63" or more
Flatness:
0.1 mm/0.004" or less
Tap hole M8 depth:
15 mm/0.59" or more
Align the guide
Flat washer
Scale bracket A
m)
•
Table
SJ300 Series