B2 Audio MA 1000.4 Owner's Manual

Owner's Manual
INTRODUCTION
Thank you for purchasing our car audio amplifier. This power amplifier has been
designed to provide high quality performance with a minimum of maintenance.
However, it's performance will only be as good as the care and quality of components
with which is installed. We therefore advise that you read these instructions very
carefully to familiarize yourself with the product and it's features.
Before installing the power amplifier please read this instruction manual carefully. The
instructions for mounting and connecting the set have to be followed precisely. If
necessary, a service center should be consulted.
All connections for DC power, signal input and speaker outputs can be carried out easily
and safely by way of RCA and screwed terminals.
INSTALLATION INSTRUCTIONS
Please choose a mounting place without any direct weather influences. Note that the
amplifier generates heat so that a well ventilated place is necessary. According to your
car's construction the set can be made very carefully in order to ensure the amplifier's full
performance and reliability.
Keep the wire connections as short as possible with sufficient dimensions in order to
minimize power losses and provide a higher audio output of the system.
For safety reasons route all power and speaker wiring by using the exiting wire channels.
To minimize damage to the cables, take care that they do not pass sharp edged metal.
Lay all cables as far away as possible from the ignition cables, modules in the boot and
under the key dashboard, as this create interference.
Add a fuse into the (+) power cable in a distance of not more than 30 cm from the
positive battery pole.
Keep the length of the power wires as short as possible. It is better to use power cables
which are short and then longer speaker cables.
In order to reduce interference, also pay attention to the instructions.
- 1 -