Maintenance Inspection; Specific Safety Rules For Trimmer Use - GardenMaster GM43PBC Safety And Operating Manual

2. Replace any damaged parts.
3. Check that all fasteners, guards and handles
etc are in place and secure. Tighten as
necessary.
4. Check the fuel level. Starting with a full tank
will help to eliminate or reduce operating
interruptions for refueling.

MAINTENANCE INSPECTION

1. Check the air filter. A dirty air filter will restrict
airflow to the carburetor, reducing engine and
cutting performance.
2. Check the throttle cable free play. The cable
must be correctly adjusted and operate
smoothly for good throttle control.
3. Look for signs of damage to cutting blade.
Replace the blade or if any part is worn, bent,
cracked, chipped, or damaged in any way.
4. Make sure the guards are properly installed
and securely fastened.
5. If the guards are damaged in any way replace
immediately.
ADDITIONAL SAFETY RULES
FOR GRASS TRIMMER
1. During assembly take great care when fitting
the guard, as this has a very sharp cutting
edge at one side for cutting the nylon line.
2. Never point toward other people or animals
when in use.
3. If the trimmer starts to vibrate excessively
switch off and have your dealer check the
trimmer.
4. Do not cross roads or gravel paths when
operating.
5. On steep slopes you should cut across the
grade of the slope, never up and down.
6. Never use the trimmer in rain or damp
weather. Avoid cutting wet grass as you may
slip.
7. Do not overreach. Keep proper footing
and balance at all times. Overreaching can
result in loss of balance or exposure to hot
surfaces.
8. Mix and store fuel in an approved container.
9. Mix fuel outdoor where there are no sparks
or flames. Move at least 10 feet (3 metres)
away from where you refueled before starting
engine.
10. Never smoke or use exposed light bulbs into
4 4
the area while refueling.
11. Always mop up fuel spillage as quickly as
possible. Change your clothes if you spill fuel
on yourself.
12. Stop the engine to cool. Empty the fuel tank
and secure the unit before transporting in a
vehicle.
13. Always keep feet and hands well away from
the cutting line, take special care when
starting.
14. Always stop the engine and remove the spark
plug wire before making any adjustments.
15. Never leave the machine running and
unattended.
16. Replace cutting head if cracked, chipped, or
damaged in any way. Be sure the line spool
is properly installed and securely fastened.
Failure to do so can cause serious injury.
17. Make sure all guards, straps, debris shield
and handles are properly and securely
attached.
18. Do not use any other cutting attachment with
this machine.
19. Do not use metal blades (if applicable).
20. When unloading the trimmer from the truck,
be careful not to drop the engine on the
ground as this may severely damage the fuel
tank.
21. Except in case of emergency, never drop or
throw the trimmer to the ground as this may
severely damage the trimmer.
22. Remember to lift the entire equipment from
the ground when moving the equipment.
Dragging the fuel tank is highly dangerous
and will cause damage and leakage of fuel,
possibly causing fire.
WARNING! This product is
operated with - unleaded petrol
30 parts to one (30:1) part two stroke
oil.
Incorrect oil or petrol will lead to failure and
damage.
SPECIFIC SAFETY RULES FOR
TRIMMER USE
Maintain a firm grip on both handles while
trimming. Keep bump head below waist level.
Never cut with the bump head located over 76cm
(30in) or more above the ground.