Safety Inspection - GardenMaster GM43PBC Safety And Operating Manual

b) Use only an approved container for fuel
storage and mixing.
c) Never mix petrol/ oil in the machine fuel tank.
d) Do not smoke, and avoid sparks and flames
near fuel or unit.
e) Avoid spillage of fuel or oil. Wipe up all
spillages as quickly as possible.
f) Mix fuel outdoors where there are no sparks
or flames.
g) Do not inhale fuel fumes.
h) Move at least 3 meters (10 feet) from
refueling position before starting the engine.
Stop the engine and allow to fully cool before
refueling or storing the machine.
i) Never use exposed light bulbs while
refueling.
j) Change your clothes if you spill fuel on
yourself.
k) Keep petrol and oil away from eyes. If petrol
or oil comes in contact with eyes, wash them
immediately with clean water. If irritation is
still present, seek immediate medical help.
14. Transport, handling and storage of the
unit
a) Switch off the engine when you cross roads
or gravel paths.
b) Always clean and maintain before storing,
pay special attention to the guards and
cutting attachments.
c) Before transporting the unit in a vehicle stop
the engine and allow it to cool. Empty the
fuel tank and securely locate the unit.
d) When removing the tool from a vehicle or
from storage, be careful not to drop the
engine on the ground as this may severely
damage the fuel tank.
e) Never drag the tool across the ground,
or throw it to the ground this is highly
dangerous and will damage the fuel tank,
causing the fuel to leak, possibly causing fire.
f) Remember when moving the equipment to
lift it the entirely from the ground.
15. Start and commissioning of the unit
1) For units with a clutch, check that the cutting
attachments stop turning when the engine
is at idles speed. Read instructions on filling
of fuel and oil, especially concerning fire
precautions; refer to carburetor adjustment
section.
2) Read instructions on filling of fuel and oil,
especially concerning fire precautions and to
carburetor adjustment section.
3) Always switch off the engine and allow it to
cool before making any adjustments
4) Make sure all guards, straps, debris shield
and handles are properly and securely
attached.
16. Rain
Never use the trimmer in rain or damp weather
conditions. Avoid cutting wet grass as you may
slip.
17. Injuries by rotating parts
Do not touch rotating or moving parts until they
have come to a complete stop.
Switch off the engine before attempting
maintenance.
Do not remove wrapped twigs or other debris
from moving or rotating parts whilst motor is
running. Switch off the engine before attempting
maintenance.
18. Transport, handling and storage of the
unit
Clean and maintain before storage, including
guard and metal attachments.
ADDITIONAL SAFETY
RULES FOR YOUR BRUSH
CUTTER
1. Do not use the blade above 5cm (2 inches)
from the ground.
2. If the brush cutter starts to vibrate
excessively switch off and contact the
Helpline for advice.
3. Replace or turn cutting knife if cracked,
chipped, or damaged in any way. Be sure
the knife is properly installed and securely
fastened. Failure to do so can cause serious
injury.
4. Do not use any other cutting attachment with
this machine Use only the parts provided or
available as spare parts. Do not use adaptors
and parts from other machines. Saw blades
should not be used.

SAFETY INSPECTION

1. Look around the engine for signs of oil or
petrol. Wipe up any spills before starting the
engine.
3 3