Lenze SMVector Reference Manual page 5

DANGER!
• After the controller has been disconnected from the supply voltage, do not touch the live components and power
connection until the capacitors have discharged. Please observe the corresponding notes on the controller.
• Do not continuously cycle input power to the controller more than once every three minutes.
• Please close all protective covers and doors during operation.
WARNING!
Network control permits automatic starting and stopping of the inverter drive. The system design must incorporate ad-
equate protection to prevent personnel from accessing moving equipment while power is applied to the drive system.
Pictographs used in these instructions
Pictograph Signal word
DANGER!
WARNING!
STOP!
NOTE
Safety Information
Meaning
Warning of Hazardous Electrical Voltage.
Impending or possible danger for persons
Possible damage to equipment
Useful tip: If observed, it will make using
the drive easier
3
Consequences if ignored
Reference to an imminent danger that may
result in death or serious personal injury if the
corresponding measures are not taken.
Death or injury
Damage to drive system or its surroundings
CMVDVN01A