Setting example
:
2
The user set saved in the channel 2 is loaded.
>USERSET-LOAD 2
User set name
Strings that are 31 characters long can be assigned to
channels 0 to 16. For example, you can assign names
such as "setting1" and "setting2" in accordance with the
settings.
Command
USERSET-NAME
31 characters of your choice
User set memory
This is one of the items to be saved in the user set
channel. Signed 32-bit numbers are assigned to slots 0 to
15.
Configuration diagram of user set
Free Memory
Signed 32-bit numbers can be saved and loaded to 8192
areas.
Command
Parameter1
FREE-MEMORY
0 to 8191
User ID
User IDs are unique names that can be assigned to
cameras. A string that is 15 characters long can be
assigned.
Command
USER-ID
15 characters of your choice
Parameter
Factory setting
Parameter2
31
31
-2
to 2
- 1
Parameter
Saving and Startup
The startup setting can be determined by USERSET-
DEFAULT. This is also used to check which user set
settings are currently being used.
Usage example:
Startup with the setting saved in the user set channel 3.
>USERSET-DEFAULT 3
(Restart or RESET command)
Check which user set settings are the current settings.
>USERSET-DEFAULT
0
OK
Initializing
Perform "USERSET-LOAD 0" if you want to format
only the camera settings.
Perform the commands below only when you want to
restore all settings (ex. Boa rate not stored in user set and
the camera link tap) to the factory settings.
Note
Defect data, shading data will be eliminated as well.
Command
FACTORY-DEFAULT
Camera Information
The model name of a camera or its firmware information
can be read out.
Command
VENDOR
MODEL
VERSION
ID
MANUFACTURER
41
Read out items
Manufacture name (SONY)
Model name
Firmware version
Serial number
Data for service