Installing The Drive Belt - GE GFDS350ELWW Service Manual

Installing the Drive Belt

1. Remove the front panel.
2. Reach under the left-hand side of
the drum, push the idler pulley down
and to the right, and lock the pulley
shaft on the top corner of the
motor bracket.
3. Place the belt in position around the
center of the drum through the front of
the dryer.
4. Place the belt in position around the
View from rear of dryer
motor pulley (see diagram), release
the idler pulley from the motor bracket,
and guide onto the belt.
Note: Check to make sure the belt is
in place and not twisted before
installing the top and front panels.
47
Copyright 2011