Drive Belt
Drive Belt Removal
1. Disconnect power from the unit .
2. Remove the control panel.
See Control Panel Removal on page 20.
3. Remove the front panel.
See Front Panel Removal on page 24.
4. Remove the front drum support .
Drum
The drum felt is a part of the drum and can not
be replaced separately. The drum can be installed
backward. When viewing from the front of dryer, the
its highest point on the right as shown in the picture
above.
Drum Removal
1. Disconnect power from the unit .
2. Remove the control panel.
See Control Panel Removal on page 20.
3. Remove the front panel.
See Front Panel Removal on page 24.
4. Remove the trap duct .
See Trap Duct Removal on page 38.
5. Remove the drum lamp.
See LED Drum Lamp Removal on page 33.
See Incandescent Drum Lamp Removal on
page 34.
6. Remove the front drum support .
See Front Drum Support Removal on page 34.
7. Remove the belt .
8. Pull the drum out from the front of the dryer.
Rear Drum Support
Rear Drum Support Removal
1. Disconnect power from the unit .
2. Remove the control panel.
See Control Panel Removal on page 20.
3. Remove the front panel.
See Front Panel Removal on page 24.
4. Remove the trap duct .
See Trap Duct Removal on page 38.
5. Remove the drum lamp.
See LED Drum Lamp Removal on page 33.
See Incandescent Drum Lamp Removal on
page 34.
6. Remove the front drum support .
See Front Drum Support Removal on page 34.
7. Remove the belt .
8. Pull the drum out from the front of the dryer.
9. Remove the rear panel.
See Rear Panel Removal on page 26.
10. Remove the rear duct .
35