GE GFDS350ELWW Service Manual page 33

Disassembly – Air Duct Assembly
Trap Duct Felt Seal
Sensor Rod Ground Wire
The air duct assembly houses the lint filter, steam nozzle, drum seal,
and the 2 sensor rods. It is located on the back side of the front panel.
To remove the air duct assembly:
1. Remove the front panel.
2. Remove the single Phillips-head screw that attaches the sensor
ground wire to the cabinet.
Copyright 2011
NOTE:
The trap duct felt seal can be
replaced by extracting the seal
from the channel located on the
air duct assembly.
33