ABB CM30 User Manual page 29

ControlMaster CM30 and CM50
Universal process controllers,
...Display
Operator Functions
Autoscroll
Soft Key Function
Configuration
Auto/Manual
Local / Remote
Scroll View
Alarm Ack
Toggle Signal
Edge Signal
Auto Manual Enable
Local Remote Enable
Alarm Ack. Enable
Totalizer Stop/Go
Totalizer Reset
SP Adjust Enable
IM/CM/ED–EN Rev. B
1 1
/ and / DIN
4 2
When enabled (On), Operator pages (see page 16) are scrolled continuously at
intervals of 10 seconds per page.
Assigns a dedicated function to the Navigation key (right) – see page 6.
Displays the Access Level enabling selection of configuration levels – see page 17.
Toggles between Auto and Manual control modes.
Toggles between Local and Remote setpoint modes.
Scrolls through each available Operator view.
Acknowledges all active unacknowledged alarms.
Provides a source that toggles between 2 states – can be assigned to outputs or used
to select sources.
Provides an edge-triggered source that is active on key press. Can be assigned to
outputs or used to select sources
Turns on / off the ability for Auto / Manual control mode to be changed in Operator
Level.
Turns on / off the ability for local / remote setpoint mode to be changed in Operator
Level.
Turns on / off the ability to acknowledge alarms from the front panel.
Turns on / off the ability to start / stop the totalizer.
Turns on / off the ability to reset the totalizer.
Turns on / off setpoint adjustment in the Operator Level.
7 Advanced Level
27