Start Up The System - Cisco TelePresence MX200 G2 Installation Manual

Installing Cisco TelePresence MX200 G2 - Table Stand
3
Lead out the cables
Lead the cables downward and out at the back.
78-100247-02A0 | JUNE 2016 | © 2016 Cisco Systems, Inc. All rights reserved.
Snap on the cable
channel lid for strain relief.
4

Start up the system

• Connect to power and LAN/Ethernet.
• Switch on the system. The power switch is next
to the power connector at the rear side of the
system.
Wait while the unit starts up. Normally this takes a few minutes.
It may include automatic software upgrade and restart of the
Touch controller.
• Follow the instructions on the Touch controller.
Cisco Spark: To find more information on how to get started
with Spark registered systems, visit
and look for Getting Started articles for room systems.
Other services: For further information on set-up and
configuration, download the Getting Started Guide from the
Cisco web site, http://www.cisco.com/go/mx-docs
Never move the camera manually when power is switched on;
always use the camera control function on the Touch controller
to change the camera position.
http://help.ciscospark.com
5