Cleaning Recommendations - Pacific hydrostar 95672 Set Up And Operating Instructions Manual

Hide thumbs

Table of Contents

Available languages

Clean an inconspicuous test area to help avoid damaging the surface: Always begin

with the fan spray at a distance of about -5 feet from the surface being cleaned to

avoid damaging the surface of the object. Make sure that the test area is clear of

people and water prone/delicate objects. If a pressure washing detergent is to be

used, apply the detergent to this area as well. After cleaning this area, switch off the

pressure washer and inspect the area carefully for any damage or discoloration. If

any damage is noted from the pressure setting, use a lighter setting when cleaning

the rest of the area. If damage or discoloration is noted from the detergent, do not

use it when cleaning.

First, pass over the area with a light cleaning, and then more thoroughly clean it.

For a vertical or sloped surface:

Wash from the top down.

If possible, direct the stream in the same direction as the slope towards a drain-

ing area. This will enable better drainage and therefore better cleaning.

For a flat surface:

If a thin layer of water accumulates on the surface, periodically use the stream

to direct this water towards the drainage.

After the major cleaning is done, sweep the surface with the stream to help direct

loose debris toward the drainage.

If detergent is to be applied: Only use pressure washing detergent; other detergents

might clog or damage the pressure washer. Apply the detergent at low pressure by

pulling the end of the Adjustable Lance () out away from the Lance Gun. Allow

the detergent several minutes to sit and soak into the work surface; this will improve

cleaning efficiency. Make certain to rinse off all detergent completely. Switch the

Adjustable Lance back to high pressure when done applying detergent.

Hold the Lance Gun at about a 45° angle and steadily sweep the stream back

and forth; if a severe, head-on angle is used, dirt may imbed in the surface being

cleaned. Follow a steady, consistent pace during cleaning; this will help prevent

stripes or discoloration afterwards. If streaking or uneven cleaning is noted at the

end of a project, go over the edges of the streaks with a wide fan pattern to help

blend these lighter areas in.

If several different surfaces are to be cleaned, be careful not to damage any of the

less solid surfaces while trying to clean the harder ones. This is especially a concern

when cleaning tile and grout, bricks and mortar, or stones and mortar.

If wood is being cleaned, be careful not to damage it. Wood will usually require

resurfacing (sanding) and re-coat with a surface protectant (wood, stain, varnish)

after it has dried again. Try to avoid leaving water on a wooden surface; doing so

can harm the surface.

For technical questions, please call 1-800-444-3353;

SKU 95672