Wiring Connection - JVC KD-R988BTS Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT
We recommend installing the unit with a commercially available custom
wiring harness specific for your car and leave this job to professionals for
your safety. Consult your car audio dealer.
KD-R988BTS: MIC (Microphone
input terminal) ( 14)
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
Blue:
(separately purchased)
To power antenna
Blue/white:
To amplifier
Brown (not used)
Recommended connection
Output
terminals
( 34)
Antenna terminal
Light blue/yellow
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (12 V
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/3-way crossover: Mid range speaker (right)
Gray/black
White: Front speaker/3-way crossover: Mid range speaker (left)
White/black
Purple: Rear speaker/3-way crossover: Tweeter (right)
Purple/black
Green: Rear speaker * 2
/3-way crossover: Tweeter (left)
Green/black *
2
Fuse (10 A)
350 mA)
Separate red wire
Make this connection if your vehicle factory wiring
harness does not have "12 V ignition switch" wire.
* 1
Firmly connect the ground wire of the amplifier to the
car's chassis to avoid damaging the unit.
* 2
You can also connect a subwoofer speaker directly using
this lead without an external subwoofer amplifier. For
setting,
Signal cord (not supplied)
JVC Amplifier *
KD-R988BTS: USB cable (DC 5 V
1.5 A) (approx. 1.2 m/4 feet)
KD-R988BTS:
Expansion port (12 V 500 mA)
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
KD-R888BT:
Microphone input jack ( 14)
Remote wire (not supplied)
Ignition switch
Car fuse block
24.
ENGLISH
1
35