Furuno VR-7000 Installation Manual page 57

5. Insert the center pin to the core and sol-
der.
7. Completed.
2.7.3 Connections
1. Remove the outside cover of the video LAN converter; hold the right and left sides
of the cover and pull the cover outward.
2. Remove eight binding screws (M3x6) to detach the chassis cover.
3. Fabricate the power cable.
Remove the armor and vinyl sheath by 226 mm, then expose the signal cores by
6 mm. Wrap vinyl tape around the edge of the armor.
Center pin
Binding screws (8 pcs)
Chassis cover
Vinyl sheath
Armor
Vinyl tape
6. Screw the shell into the cable.
Shell
226 226
6
2. WIRING
2-21