Fabrication Of The Coaxial Cable; How To Attach The Bnc Connector; Converter - Furuno VR-7000 Installation Manual

2. WIRING
2.7.2

Fabrication of the coaxial cable

When you connect the IF-7100 with a radar or ECDIS using the coaxial cable, prepare
the optional cable shown below.
• BNCX5-DSUB15-L400: D-SUB-BNC connector cable
• CP24-01200/01210*: Coaxial cable (six core, unfabricated) with BNC connectors
*: When you need either the coaxial cable or the BNC connector individually, prepare
the optional ECX-3C-2V-T cable (three core) and FB-SPM1D+ connector (BNC con-
nector).
Fabricate the coaxial cable as follows:
CP24-01200/01210:
Attach the BNC connectors, referring to

"How to attach the BNC connector".

To Radar/
ECDIS
To Radar/
ECDIS
How to attach the BNC connector
1. Pass the clamping nut, washer, and
gasket onto the cable.
3. Remove the shield and insulator by 3
mm.
2-20
Wrap the vinyl tape after
connecting the BNC connectors.
Washer
Clamping nut
Gasket
3
BNCX5-DSUB15-L400
Shield:
Fix to the frame ground.
2. Remove the vinyl sheath by 7 mm.
4. Pass the clamp onto the cable and
fold back the shield on to the clamp.
To video LAN

converter

To video LAN
converter
7
Clamp
Shield