Cable Fabrication; Notes For Wiring - Furuno VR-7000 Installation Manual

Cable fabrication

• DPYCY-1.5 cable
35
Cable jacket Cable jacket
Fasten this part with the cable gland.
• FR-FTPC-CY cable
35
Cable jacket Cable jacket
Fasten this part with the cable gland.

Notes for wiring

• Insert the rod terminals to the terminal board securely and fasten the terminal
board screws to keep the wires from touching the terminal board cover.
• When it is hard to attach the rod terminal to the cores of the DPYCY-1.5 cable,
cut out the wire jacket. Be careful not to damage the cores when cutting the wire
jacket
Wire jacket
Cut the wire jacket.
• When it is hard to insert the rod terminals attached to the FR-FTPC-CY cable
to the terminal board, cut the rod terminal about 2 mm.
20
100
Twist the wires.
Vinyl sheath
Vinyl tape (width: 10)
20
100
Cut the unused wires.
Vinyl sheath
Vinyl tape (width: 10)
Core
Attach the rod terminal.
Attach the rod terminal.
Rod terminal
Attach the rod terminal to the core.
2. WIRING
2-11