Parameters
The figure below shows the structure of the parameters for channels 0 to 1.
You can activate a parameter by setting the corresponding bit to "1".
* x = 2 + (channel number x 6); channel number = 0 to 1
Figure A-3
Codes for output type
The following table contains the codes for the output types of the analog output module. You
must enter these codes in byte x (see previous figure).
Table A- 1
Output range for voltage
Deactivated
Voltage
Current
Analog output module AQ 2xU/I HF (6ES7135-6HB00-0CA1)
Manual, 02/2014, A5E33062529-AA
A.2 Parameter assignment and structure of parameter data record
Structure of byte x to x+5 for channel 0 and 1
Codes for output type
Code
0000 0000
0000 0001
0000 0011
Parameter data record
27