Parameters - Siemens Simatic ET 200SP Manual

Parameters/address space
4.3 Explanation of parameters
4.2

Parameters

Parameters of the AQ 2xU/I HF
The following table lists the configurable parameters. The effective range of the configurable
parameters depends on the type of configuration. The following configurations are possible:
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation on PROFIBUS DP in an ET 200SP system
When assigning parameters in the user program, use the WRREC instruction to transfer the
parameters to the module by means of data records; refer to the section Parameter
assignment and structure of parameter data record (Page 25).
The following parameter settings are possible:
Table 4- 2 Configurable parameters and their defaults (GSD file)
Parameter
Diagnostics:
Missing supply voltage L+
Diagnostics:
Short-circuit to ground
1
Diagnostics:
Overflow
3
Diagnostics:
Underflow
3
Diagnostics:
Wire break
2
Output type/range
12
Value range
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Deactivated
•
Voltage ±10 V
•
Voltage ±5 V
•
Voltage 0..10 V
•
Voltage 1..5 V
•
Current ±20 mA
•
Current 0 - 20 mA
•
Current 4 - 20 mA
•
Default Reconfigu-
ration in
RUN
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Current 4 - 20 mA Yes
Analog output module AQ 2xU/I HF (6ES7135-6HB00-0CA1)
Scope with configuration
software, e.g. STEP 7
(TIA Portal)
GSD file GSD file
PROFINET PROFIBUS
IO DP
Channel Channel
Channel Channel
Channel Channel
Channel Channel
Channel Channel
Channel Channel
Manual, 02/2014, A5E33062529-AA
3