Reset To Factory Default Settings - Axis Q3505-SVE Mk II Installation Manual

5. Click Go to to set the camera in your preset position.
6. Click Save.
To set limits for focus and zoom:
1. Go to Video & Audio > Focus & Zoom.
2. Select a value in the drop-down list for Zoom limit to limit the camera's maximum
zoom area.
The digital zoom level is indicated with the letter D.
3. To preview the zoom limit, click Go to this position.
4. Select a value in the drop-down list for Focus near limit to prevent the camera from
focusing on objects that are too close.
5. Click Save.
Note
You can still set focus and zoom in Video & Audio > Focus & Zoom, but your settings are
not saved after camera restart.

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available from the support pages
on www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware Overview on
page 10.
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup >
System Options > Maintenance and click Default.
AXIS Q3505-SVE Mk II Network Camera
21