Table of Contents
Advertisement
Depending on whether you want to use a junction box, or route the cables through or along the
wall, follow the relevant instructions below.
To mount the camera on a junction box:
1. Attach the adhesive gasket to the back of the mounting bracket.
2. Route the network cable (and the multicable if required) through the junction box and
through the hole in the mounting bracket.
3. Attach the mounting bracket to the junction box with appropriate stainless screws.
To route cables through the wall:
1. Using the drill template drill 4 holes for mounting the bracket, and a hole for routing the
cables through the wall.
2. Attach the adhesive gasket to the back of the mounting bracket.
3. Route the network cable (and the multicable if required) through the wall and through
the hole in the mounting bracket.
4. Attach the mounting bracket to the wall with appropriate stainless screws.
To route the cables along the wall and through the side hole on the mounting bracket:
1. Attach the adhesive gasket to the back of the mounting bracket.
2. Unscrew the plug from the side hole on the mounting bracket.
3. Route the network cable (and the multicable if required) through the conduit and
through the hole in the mounting bracket.
4. Attach the mounting bracket to the wall with appropriate stainless screws.
5. Attach the conduit to the mounting bracket.
Connect cables and attach camera to mounting bracket
1. Insert the microSD card in the camera unit (optional).
2. Remove the cable gasket for the network cable from the unit casing, see Hardware
Overview on page 10.
3. Pull to remove the tab on the gasket, and use the provided connector guard to push the
network cable through the gasket. Pull the network cable back slightly so that the
cable gasket adjusts itself on the cable.
AXIS Q3505-SVE Mk II Network Camera
17
Advertisement
Table of Contents
