this device complies with part 15 of the fCC rules. operation is subject to the following two conditions: (1) this
device may not cause harmful interference; and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
this equipment has been tested and found to comply with the limits for a Class b digital device, pursuant to part 15 of
the fCC rules. these limits are designed to provide reasonable protection against harmful interference in a residential
this equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
• reorient or relocate the receiving antenna (that is, the antenna for radio or television that is "receiving" the interference).
• reorient or relocate and increase the separation between the telecommunications equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a circuit different from that to which the receiving
antenna is connected.
If these measures do not eliminate the interference, please consult your dealer or an experienced radio/television tech-
nician for additional suggestions. also, the federal Communications Commission has prepared a helpful booklet, "how
to Identify and resolve radio/tv Interference problems." this booklet is available from the u.s. government printing
office, washington, D.C. 20402. please specify stock number 004-000-00345-4 when ordering copies.
Electrical pulse noise is present at one time or another. this is most intense during electrical storms. Certain kinds
of electrical equipment, such as light dimmers, fluorescent bulbs, motors, fans, etc., also generate pulse noise. because
radio frequencies are susceptible to this, you may on occasion hear pulse noise through the receiver. this is usually only
a minor annoyance and should not be interpreted as a defect of the unit.
fCC rf radiation Exposure statement
this equipment complies with fCC rf radiation exposure limits set forth for an uncontrolled environment. this equip-
ment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
for hand held operation, this phone has been tested and meets the fCC rf exposure guidelines. use of other acces-
sories may not ensure compliance with fCC rf exposure guidelines.
hearing aid Compatibility (haC)
this telephone system meets fCC and Industry Canada standards for hearing aid Compatibility.