Nevertheless, you have to change the telephone line cord adapter according to the country where you want to use it. (See battery status icon on page 4.) Code dial 153 www.philips.com/faqs/dect...
1. Dispose of the complete product (including its cables, plugs and accessories) in the designated WEEE collection facilities. 2. If you purchase a replacement product, hand your complete old product back to the retailer. He should accept it as required by the WEEE directive. www.philips.com/faqs/dect Recycling & Disposal...
The information included in this manual are valid for DECT 214 multihandset packs. Philips has marked the battery and packaging with standard symbols designed to promote the recycling and appropriate disposal of your eventual waste. Batteries should not be disposed of with general household waste.
Page 6
Keypad Talk key Phonebook keys Call log key Redial list & correction key Validation and intercom key Loudspeaker key Programming and recall type key Volume key www.philips.com/faqs/dect DECT 214 Handset DECT 214 p 11...
Page 7
Base / Handset link Alarm Temperature * subject to a subscription with your operator charge in progress - fully charged - Internal call Repeat alarm key Paging key p 10 p 11 p 11 p 10 p 12 p 12 p 12 www.philips.com/faqs/dect...
✦ Calling a number from the redial list to scroll through the redial list ✦ Deleting a number from the redial list to scroll through the redial list www.philips.com/faqs/dect Using the telephone to scroll through the list to delete the current entry...
Page 9
You can also create an entry from the redial list and the call Press access or exit phonebooks. www.philips.com/faqs/dect...
✦ Deleting an entry from the call log to scroll through the log ✦ Storing one of the log numbers into your phonebooks to scroll through the log www.philips.com/faqs/dect to exit beep to exit beep...
To enter the programming mode press Icons representing the menus will then be displayed on the screen : Volume and melody settings (VIP melodies*) Handset registering Other settings again. www.philips.com/faqs/dect Intercom & call transfer are only possible with handsets* registered to the same base station.
1 base station. ✦ To register another handset First enter registration mode by unplugging and plugging back in the power adapter to the electricity supply. www.philips.com/faqs/dect keys, press . To exit the programming mode (long press) . to validate your to validate.
Page 13
RC* code written under the base and press to confirm. Warning : If you wish to associate a non-Philips handset to the DECT 214 base station, make sure that these handsets are GAP compliant otherwise they will not operate properly.
Note: If you have set the 12-hour time format, a (ante meridiem) or p (post meridiem) are displayed. Changing temperature units C (degree Celsius) or ✦ to select www.philips.com/faqs/dect on or off. to activate the display backlight to read time at night. F (degree Fahrenheit) C (default) or The digits to...
✦ Telephone troubleshooting... ! Please read this user guide carefully before calling your Philips Customer Care Center. ! IF NEEDED, check that the appropriate country code is set in the phone : PROBLEMS - No dialling tone when pressing icon is blinking.
✦ Declaration of Conformity : PHILIPS Consumer Electronics Route d'Angers 72081 Le Mans Cedex 9 France Declare that the products DECT214xx are in compliance with ANNEX IV of the R&TTE-Directive 1999/5/EC and then with the following essential requirements : Article 3.1 a : (protection of the health & the safety of the user)