SodaStream PLAY Drinks Maker Quick Start Manual page 7

INSTALL THE CO CYLINDER
Adaptor
Collar
2
1. Place the PLAY™Drinks Maker
on a flat, sturdy surface, then
gently lay it down on its back with
the carbonating block facing
upwards.
2. Remove seal and cap from the
SodaStream CO
Remove the carbonating bottle
stored inside the PLAY™and then
insert the CO cylinder into the
2
opening of the cylinder hollow at
the base of the PLAY
Maker and turn the CO cylinder
clockwise while applying gentle
pressure until it is firmly held in
place. Hand-tighten only; do not
use tools.
TM
If the PLAY Drinks Maker is not
laying on its back with the
c a r b o n a t i n g b l o c k f a c i n g
upwards, a safety gate will block
the cylinder hollow and you will
not be able to fully insert the
cylinder.
If using a 130L cylinder, remove
the cylinder adaptor collar by
pulling it out from the base of the
unit.
3. Place your PLAY™Drinks Maker
back in the upright position.
You are ready to create the
bubbles.
cylinder.
2
TM
Drinks
2
7