Furuno NAVpilot-700 Installation Instructions Manual page 9

5. Select [INSTALLATION] then push the knob to show the [INSTALLATION] menu.
For how to set the [INSTALLATION] menu, see the document below.
• NAVpilot-700/711: Installation manual (IME-72720)
• NAVpilot-711C: Operator's manual (OME-72780)
Note1: The [INSTALLATION] menu can be opened from the STBY display by pressing the
knob three times while pressing and holding down the MENU key.
Note2: Set [BOAT TYPE] to [EVCS BOAT] on the [SHIP'S CHARACTERISTICS] menu to
connect to the EVC system.
INSTALLATION MENU
LANGUAGE: ENGLISH
UNITS SETUP
DISPLAY SETUP
SHIP'S CHARACTERISTICS
CAN BUS SETUP
NMEA0183 SETUP
SENSOR SELECTION
UNIVERSAL PORT
SEA TRIAL
COMPASS CALIBRATION: NO*
DATA CALIBRATION
PARAMETER SETUP
AUTO OPTION
NAV OPTION
1
* : NO is replaced with DONE when
respective setup is completed.
Check points before cruising
Check the following points before cruising.
• Confirm that no error message appears.
• When the EVC system controls the rudder, the OVRD (override) mode is automatically enabled.
• The rudder turns according to the
NAVpilot-700 [INSTALLATION] menu
([BOAT TYPE]=[EVCS BOAT])
Page 1
1 2
,
*
and
Page 2
INSTALLATION MENU
FISH HUNTER OPTION
SYSTEM SETUP
RC SETUP
ALARM
2
* : Shown when PG-700 is connected.
key in the AUTO mode.
9