Fcc Compliance; Part 15 Compliance - iDirect 3000 series Installation And Safety Manual

B.1 FCC Compliance
Radiated and Conducted
Emission
B.2 Part 15 Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. The equipment uses, generates, and radiates frequency energy. If the
equipment is not installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. There is also no guarantee that
interference will not occur in a particular installation. You can determine if the
equipment is interfering with radio or television reception by removing or applying
power to the equipment and seeing if the interference goes away, or returns, when
the unit is off or on.
To meet FCC requirements, only peripherals, such as computer input/output devices,
terminals, and printers certified to comply with the Class B limits, may be attached
to this device. Operation with non-certified peripherals is likely to result in
interference to radio and TV reception.
To meet FCC requirements, shielded cables are required to connect the device to a
personal computer, peripheral, or other Class B certified device.
70
The iDirect 3000 series™ Satellite Routers comply with Class
B of Part 15 of the FCC (Federal Communications
Commission) rules as is identified by use of the FCC logo.
47CFR15 Class B, CISPR-22 Class B, EN55022 Class B.
Modification of this equipment without written authorization
from iDirect Technologies may result in this equipment no
longer complying with FCC requirements for Class B digital
devices. In that event, your right to use the equipment may
be limited by FCC regulations, and you may be required to
correct any interference to radio or television
communications at your own expense.
iDirect 3000 series™ Satellite Router Installation and Safety Manual