Table of Contents
Advertisement
Table 9
iDirect 3000 series™ Satellite Router Connectors
Label
+24/+48
5A/2.5A
TX Out
RX Out
RX In
CONSOLE
LAN A
Use high quality coaxial cable to connect the iDirect 3000 series™ Satellite Router to
the ODU equipment. iDirect recommends that you use a solid copper center
conductor, quad shield, coaxial cable with a minimum of 60% + 40% braid and double
foil shield to connect the IDU to the ODU equipment, such as:
•
RG-6 — 0.04 inch (1 mm), solid bare copper center conductor (CommScope 5782)
•
RG-11 — 0.064 inch (1.6mm), solid bare copper center conductor (5902)
The center conductor must be straight and extend 1/8 inch (3.2 mm) beyond the end
of the F-connector, and the connector should be securely crimped to the cable.
NOTE:
iDirect does not recommend using RG-59 with solid bare copper center
conductor unless the IFL length is less than 120 feet (37 m). If lower RF
insertion loss is required due to the distant between the IDU chassis and
the ODU equipment, then RG-11 or other 75-ohm types of coax can be
used.
32
Connector Type
Interface and Purpose
Kycon KPJ-4S-S
DC input from External Power Supply
(Note: The 3000 series router is only
available in +24V. Some older versions may
have the +48 VDC label. You cannot use a
+48 VDC power supply. Doing so damages
the IDU).
75 ohm, F-Type
L-band Transmit signal to Block
Female
UpConverter (BUC) capable of 10 MHz
Reference and 24 VDC power to BUC.
75 ohm, F-Type with
Monitor of the actual receive signal from
DC Blocked
LNB Output, -10 dB nominal composite,
Termination Female
buffered.
75 ohm, F-Type
L-band receive signal, capable of 10 MHz
Female
Reference and DC power to LNB
75 ohm, F-Connector female
RJ-45
RS-232, servicing serial connection console
to PC or laptop
RJ-45
Category-5 STP or UTP cable,
10/100 Base-T Ethernet LAN port connects
the 3000 series router to the customer's
LAN Hub/switch.
iDirect 3000 series™ Satellite Router Installation and Safety Manual
Hide quick links:
Advertisement
Table of Contents
