Starting The Meap Applications - Canon imageRUNNER ADVANCE C2020 Setup Manual


Click [Browse] → select the license file and the
application file to install → click [Next].
File extensions:
License File: A file with the 'lic' extension.
Application File: A file with the 'jar' extension.
• You cannot install license files only.
• When installing the MEAP application, make sure you specify
the license file. You cannot install the MEAP application without
specifying the license file.
You can also specify the file path by entering it directly.

Confirm the information displayed on the install
confirmation page → click [Yes].
Depending on the MEAP application, a software license
agreement screen may be displayed. Confirm the information
displayed on the screen → click [OK].
If you are installing a new MEAP application, the following
information is displayed on the screen.
• Application Information
• License Information
The following information is displayed when you overwrite a
MEAP application.
• Current Application Information
• Application Information after Overwrite
Installation will start after the message <Installing... Please
wait.> is displayed again. After the installation, click [To Manual
Installation] to display the Manual Installation screen.
To use the installed MEAP application, you must start the MEAP
application. (See "Starting the MEAP Applications, " on p. 59.)
Starting the MEAP
Applications
This section describes how to start the installed MEAP
application from the SMS screen.
For more information on SMS, see e-Manual > MEAP.

From the top page of the SMS, click [MEAP
Application Management].

Click [Start] for the application to start.
3
59